Encore Networks VSR-1200 Guía de instalación descargar pdf (Pagina 8)

Page 8 VSR-1200 Hardware Reference Module, Document 2

7 When the configuration has finished loading, press Escape until you return to the Main

Menu. (Go to Section 2.4, Using the Main Menu.)

8 To save the configured scenario (if it has not already been saved), do the following:

a Write the configuration. (See Section 2.6, Saving (Writing) the Device’s Configuration.)

b Reset the device. (Section 2.7, Restarting (Resetting) the Device.)

2.5.2 Device Addresses

To configure the device’s addresses, do the following:

1 On the Advanced Configurations menu, select Local Addresses.

2 On the Configure Local Addresses menu, select IP Address.

3 Enter the device’s IP address and press Enter. (Get the device’s IP address from your

network administrator.)

4 Select BANDIT Name.

5 Enter a unique name to identify this device in your network, and press Enter.

2.5.3 Ports

To configure software for the device’s ports, do the following:

1 On the Advanced Configurations menu, select Data Configuration.

❖ The Logical Port Protocol menu is displayed. (Table 2-2 lists the Line IDs for the

ports.)

BANDIT Plus

Configure Local Addresses

----------------------------

1) IP Address : 192.168.169.1

2) BANDIT Name : BANDIT Plus

Enter Choice :

Table 2-2. Port Identifiers (Sheet 1 of 2)

Line ID Physical (Hardware) Port Default Software Configuration

C COM/Supervisor port Comm/Supervisor

L Ethernet LAN port Ethernet

W Ethernet WAN port Ethernet

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 25 26

Sin comentarios

Encore Networks VSR-1200 Guía de instalación Pagina 8